Classification and use steps of Basin Mixer Taps

Basin mixer taps are commonly used in bathrooms and kitchens. They allow you to control the flow and temperature of water from a single spout using one or two handles. Here are the steps to use a basin mixer tap:

Turn on the water supply: Before using the tap, make sure the water supply is turned on. This is usually done using a valve located underneath the sink.

Adjust the temperature: Depending on the type of basin mixer tap, you may need to adjust the temperature using one or two handles. If there are two handles, one controls hot water and the other controls cold water. If there is only one handle, you will need to move it to the left or right to adjust the temperature.

Turn on the water flow: Once you have adjusted the temperature, turn on the water flow by lifting the handle or lever. You should hear the water start to flow.

Adjust the flow rate: If the water flow is too strong or weak, you can adjust it using the handle or lever. Moving the handle or lever forward will increase the flow rate, while moving it back will decrease it.

Turn off the water: When you are finished using the tap, turn off the water flow by lowering the handle or lever. This will stop the water from flowing.

Drain the remaining water: After turning off the tap, you may notice that there is some water left in the spout. To drain this water, simply turn the handle or lever to the left or right until the water stops flowing.

Close the valve: Finally, close the valve underneath the sink to turn off the water supply. This will prevent any water from leaking out of the tap when it is not in use.

Meanwhile，Basin mixer taps can be classified based on several factors, including:

Type of installation:

a. Deck mounted: These taps are installed on the basin or countertop.

b. Wall mounted: These taps are mounted on the wall, with the water supply coming from the wall.

Operation mechanism:

a. Single lever: These taps have a single lever for controlling the flow of water and temperature.

b. Dual lever: These taps have separate levers for controlling the flow of hot and cold water.

c. Touchless: These taps have a sensor that detects hand movements to turn the water on and off.

Design:

a. Contemporary: These taps have a modern and sleek design.

b. Traditional: These taps have a classic and timeless design.

c. Transitional: These taps have a mix of contemporary and traditional design elements.

Material:

a. Brass: These taps are made of brass, which is durable and long-lasting.

b. Stainless steel: These taps are made of stainless steel, which is resistant to corrosion and tarnishing.

c. Chrome: These taps are coated with chrome, which gives them a shiny and reflective surface.

Finish:

a. Matte: These taps have a non-shiny and dull finish.

b. Glossy: These taps have a shiny and reflective finish.

c. Brushed: These taps have a textured finish that is created by brushing the surface.

Overall, basin mixer taps can be classified based on a combination of these factors, and the choice of tap depends on the specific requirements and preferences of the user.